|
Flat Panels
Video Projectors Rear-Projection TV Receivers Speakers Disc Players Surround Pre/Pros Amplifiers Accessories Recently Added
Video Displays
Speakers
Sources
Electronics
Accessories Scott Wilkinson Thomas Norton Fred Manteghian Kim Wilson How To Features Audio/Video News Past eNewsletters CEDIA 2008 CES 2008 CEDIA 2007 HE 2007 CES 2007 CEDIA 2006 HE 2006 CES 2006 Thomas J. Norton Michael Fremer Joel Brinkley Scott Wilkinson AV Links Contact Us Flatscreen TVs LCD TVs Plasma TVs HDTV AV Receivers Home Theater in a Box Digital Projectors DLP Projectors Video Projectors Surround Sound Dolby 5.1 |
NHT VT-3 Home Theater Reference surround speaker system:
Measurements The NHT VT-3 Tower's impedance dipped to a minimum of 3.4ohms at 98Hz, and remained below 6ohms between 70 and 220Hz. In the remainder of the frequency range it never dipped below 6ohms; the specified 6ohms impedance is a reasonable value. The upper portion of the system (minus the onboard subwoofer drivers) is tuned to about 55Hz. The sensitivity measured approximately 85dB (2.83V/m)—slightly below the specified 87dB, but near enough to be accounted for by different measurement techniques. All curves shown here have 1/6-octave smoothing applied. The average front-axis horizontal response (30° forward angle plus the close-miked woofer response) is shown in Fig.1 (green). Apart from a slight dip in the midbass and a slight emphasis in the low-mid treble, the result is generally very smooth and well-controlled. There is strong bass response evident to 20Hz. We didn't measure the 45° and 60° horizontal off-axis responses because of the system's size, but the horizontal off-axis response up to 30° differed from the average shown here by a loss of only a few dB at the highest frequencies—as might be expected.
Fig.1: VT-3 Tower, 30° horizontal forward angle, average response combined with nearfield woofer response. Fig.2 shows the same average horizontal response (green) overlaid on the vertical response at 15° above (red) and 15° below (blue) the VT-3 Tower's tweeter axis. Note that you don't want to sit or stand much above the tweeter axis if you want to avoid what should be a clearly audible suckout in the 2-4kHz region. When you audition this system, sit down! Fig.2: VT-3 Tower, 30° forward angle, average horizontal response combined with nearfield woofer response (green); vertical off-axis responses at +15° (red) and –15° (blue). The VC-3 Center's impedance measured nearly identically to that of the VT-3 Tower, with the Center's cabinet tuned to 57Hz. The Center's sensitivity measured approximately 86dB (2.83V/m)—close to the specified value. The VC-3 Center's average front-axis response is shown in Fig.3 (green curve). As in Fig.1, this is the combined, pseudo-anechoic response over a 30° forward angle combined with the woofer's nearfield response. The response is smooth, though marginally less so than the VT-3 Tower's, with a moderate peak at 3kHz. This may add a trace of brightness, though MF apparently heard none. There is also a slight elevation between 400Hz and 1kHz that might push the sound forward a bit. The 45° (red) and 60° (blue) horizontal off-axis curves show no serious suckouts—a problem common in the off-axis responses of many horizontally configured center-channel speakers. The best way to minimize such suckouts is to use a 3-way design with the midrange and tweeter mounted vertically—the configuration used here. Fig.3: VC-3 Center, 30° horizontal forward angle, average response combined with nearfield woofer response (green); horizontal off-axis responses at 45° (red) and 60° (blue). Fig.4 shows the VC-3 Center's vertical responses at 15° above (red) and 15° below (blue) the main tweeter axis. The vertical off-axis deviations are minor; in fact, apart from a slight rise at about 10kHz, you could make a case for the below-axis response being smoothest in this case—not a bad thing when the speaker is mounted atop a PTV.—TJN Fig.4: VC-3 Center, 30° forward angle, average horizontal response combined with nearfield woofer response (green); vertical off-axis responses at +15° (red) and –15° (blue).
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||

